A Prismatic Part Machining and Simulation for Computer Aided Process Planning System

Viswa Mohan Pedagopu; Dr. Manish Kumar

Volume : IV, Issue : I, January - 2015

A Prismatic Part Machining and Simulation for Computer Aided Process Planning System

Viswa Mohan Pedagopu, Dr. Manish Kumar

Abstract :

The global competition between the manufacturing industries has increased the demands to reduce production times and increase quality of the product. The attempt to automate processing of geometric data and reduce the manual effort for handling complex and huge geometries has been persistently pursued over the last two decades. This pursuit has resulted in a drastic improvement in CAD systems that allow the designers to easily build complex geometries into the models. This paper presents the algorithm of tool generation of prismatic part. A case study of prismatic part has been done and the various parameters such as machining time, machining power is determined by using Creo/proe design software. This paper also shows the simulation results of prismatic part using Depth1 See NC-Mill software.