Volume : II, Issue : I, January - 2013

Optimization of Cutting Parameter in Edm Using Taguchi Method

Nirav B. Patel, Nilesh M. Vohra

Abstract :

In this Project the complexity of electrical discharge machining process which is very difficult to determine optimal cutting parameters for improving cutting performance has been reported. Optimization of operating parameters is an important step in machining, particularly for operating unconventional machining procedure like EDM. The objective of this paper is to investigate the optimum cutting parameters for a work piece (SS-304) & tool material (Copper, Aluminum, Brass) combination on Fuzzy Logic Control based Electrical Discharge Machine. In order to produce any product with desired quality by machining, proper selection of process parameters is essential. This can be accomplished by Taguchi approach. The aim of the present work is to investigate the effect of process parameters on Material remove rate (MRR), Tool wear ratio (TWR), Surface roughness (SR) to obtain the optimal setting of these cutting parameter.

Keywords :

Article: Download PDF   DOI : 10.36106/ijsr  

Cite This Article:

Nirav B. Patel,Nilesh M. Vohra Optimization of Cutting Parameter in Edm Using Taguchi Method International Journal of Scientific Research, Vol.II, Issue.I January 2013

Number of Downloads : 926

References :