Power Generation by Using Cycle RIM

Anayash Niraula; Bikash Tamang; Krishna Kumar Rai; K.S. Gouse Basha; K. Maheedhar; Ajay John Paul

Volume : III, Issue : XI, November - 2014

Power Generation by Using Cycle RIM

Anayash Niraula, Bikash Tamang, Krishna Kumar Rai, K. S. Gouse Basha, K. Maheedhar, Ajay John Paul

Abstract :

This project helps us to generate the power by using cycle rim. By giving small input of D.C supply to the system, we can easily produce large amount of power. In this project we are using 12 volts of D.C battery which is connected to a D.C series gear motor which having a very high starting torque for rotational move.Gear motor is attached to a cycle rim which is moving with high r.p.m speed nearly (600–700) r.p.m. Then by the rotation of the cycle rim the smaller wheel of the dynamo starts rotating, where cycle rim has large size compare to dynamo wheel so that while rim takes single rotation simultaneously the dynamo wheel takes 10–15 rotation which produces a very large amount of output current. Dynamo output again connected to circuit which converts the dynamo small input to a large output of A.C current upto (220–240) volt. Without any fluctuation of current/voltage.By this we can give various loads to household components such as T.v ,fans tube lights. Main advantage of this project is it will never discharge the battery before discharge of the battery the dynamo makes it fully charged so we can get continuous rotation of the cycle rim.