Volume : IV, Issue : IV, April - 2014

An Overview of Influence of Process Parameters in Case of Drilling of Composites

Mitesh Gohil, Ayanesh Y. Joshi, Sankalp B. Bhatiya

Abstract :

 Drilling of glass fiber reinforced plastic (GFRP) composite is substantially different from metallic materials due to its mechanical properties. Drilling of this material may generate delamination of drilled holes on work piece. The purpose of this review article is to investigate the influence of the cutting parameters, such as cutting speed, feed rate, point angle and volume fraction on delamination produced in case of drilling a GFRP composite. It is essential to measure Delamination, Surface roughness, Torque and Thrust Forces to optimize cutting parameters. Taguchi method and analysis of variance method (ANOVA) is used for minimization of delamination.

Keywords :

Article: Download PDF   DOI : 10.36106/ijar  

Cite This Article:

"Mitesh Gohil, Ayanesh Y. Joshi, Sankalp B. Bhatiya An Overview of Influence of Process Parameters in Case of Drilling of Composites Indian Journal of Applied Research, Vol.IV, Issue. IV

Number of Downloads : 1021

References :